Oil Flushing System is used for Turbines and hydraulic equipment. This is done, so that to ensure that the system run smoothly and start up. It is also considerably decreases the failure rate of the system. Oil Flushing is done usually before adding oil and especially while working because of the amount of contamination that can be found in the system. As usual, the main antagonist being water and then in any order, dirt, sand. Oil, rust and so on.

After a while, the system (Engine or any other equipment that uses Lubricants) would need to be Flushed which in-turn would separate and remove the sediments or any unwanted materials which would clog the system (The soluble or insoluble in the oil are harmful pollutants which would not only decrease the system efficiency, increase the system failures but could and will bring down the system to a point that it can no longer be repairable)

 

Washing the Equipment  and flushing of pipes and tanks

The operator can normally recognize the Flushing time by:  observing inside the gearbox, hydraulic systems, ball-bearings, uncommon increase in tank temperature and the amount of wear through oil analysis.

 

Flushing procedures:

Flushing equipment manufactured by us, comes in different capacities according to pipe and tank sizes and flushing procedures.

 

Niroonamad oil flushing systems

Oil Flashing Systems

logo 2